Zeitschrift für Bau- und Umweltingenieurwesen

This paper represents a comparative study aiming to investigate the heat impact on the vertical surfaces of buildings temperature based on their thermal behaviors. This study was carried out based on four building materials commonly used in Malaysia namely brick, concrete, granite and white concrete tiles. In order to investigate the thermal performance on the building materials, surface temperature sensors, data logging system as well as infrared thermography procedures were used, respectively. As the thermal impact to the materials was measured using infrared thermometric and thermographic, a field work of thermal value can be simply observed as a “seeing heat” effect. The results indicate that bricks had the capability to absorb and store heat greater than other materials during peak daytime event. The normalized (total heat/solar radiation) of brick materials was 0.093, which was the highest value compared to others. A brick material shows the highest impact of heat in 51% than white granite material and it releases a substantial amount of heat into the atmosphere through radiation and convection factors. The types of material used at exterior wall buildings have significant impact to the surrounding environment. The use of suitable materials contributes to the reduction of the air temperature due to heat transfer phenomena.

Activated carbons were obtained from cocoa pod husk using two different initial particle sizes (ranges 0.25 – 0.50mm and 0.50 – 1.00mm), three chemical activation agents (K2CO3, KOH and ZnCl2) and carbonization under nitrogen atmosphere during two hours at three different temperatures (500°C, 650°C and 800°C). The prepared activated carbons were characterized using Brunauer–Emmett–Teller (BET) and Langmuir surface areas, pore volume, average pore size, bulk density, moisture, ash content, and yield. The five best activated carbons were selected for further experiments according to the chemical activation agent used, high BET surface area, high pore volume and low ash content. Additionally, content of impurities, carbon content and FE-SEM micrographs were determined for these five best activated carbons. As adsorption tests were also carried out with these samples. Results of the experiments show that cocoa pod husk is a material that can be used to produce activated carbon by chemical activation and ZnCl2 showed to be the best chemical activation agent based on the highest BET surface area (780 m2/g in the best case) and pore volume (0.58 m3/g in the best case), the lowest ash content (6.14% in the best case), and the highest carbon content (86.1% in the best case), compared with others chemicals. Carbons activated by ZnCl2 are capable to adsorb As(V), getting As(V) removal levels up to 80% in less than 1 hour in the experimental conditions applied (initial pH 6-7, activated carbon concentration 0.1 g/l and 0.5 g/l, initial As concentration 100 ppb).

The effects of using alkaline white mud as substitutes for cement property in the process of clinker burning were investigated in this paper. Samples were prepared with adding 0.5-5.0% of alkaline white mud as substitutes for unit raw meal and then these mixtures were burned at 1450°C for 2 hrs. The results showed that the compressive strength and flexibility strength of the pastes were a little better than the plain sample. The concentrations of MgO, SO3 and chloride ions in clinkers were far below the limits in the standards when the addition of alkaline white mud was below the content of 5.0%. The Results also showed that the concentrations of free lime were in a growing tendency with the increasing of alkaline white mud. Moreover, the addition of AWM in raw meal increased the content of C3S phase in the clinker, something leading the increase of the setting times and enhances the strengths of the cement pastes in the early curing ages.